VENTS 100 Quiet-Style A - intellectual fan for bathroom, kitchen and living room

VENTS 100 Quiet-Style A is an intellectual domestic fan for shower rooms, bathrooms, kitchens and other domestic spaces. Minimalistic design of the fan would suit any type of interior.

Casing, impeller and front panels are made of durable plastic that is resistant to ultraviolet. Therefore, fan will neither change it’s colour nor deform over time. It is compatible with Ø 100 mm air ducts and suitable both for wall and ceiling mounting.

VENTS 100 Quiet-Style A has IP 45 protection rating. The fan is protected against small (less than 1 mm) objects that may harm it by falling inside. Also, protection against water and humidity makes it a good choice for bathroom or kitchen.

The fan’s motor is aimed at stable, quiet and energy saving performance. It combines low energy demand (7.5 W) and low noise level that is provided by anti-vibration dampers. Maintenance-free bearings contain enough grease for 40 000 hrs of non-stop operation. Motor is equipped with overheating protection.

VENTS 100 Quiet-Style A
 can be controlled by a room light switch, built-in pull cord or thyristor speed controller. Also, you can connect it to the electronic control unit BU-1-60, timer T or combined humidity sensor and timer TH that automatically turns on the fan in case certain humidity level is exceeded.

Rate the video

Video with the same plot

VENTS VUE2 250 P EC: mounting of the suspended air handling unit in a flat

VENTS VUE2 250 P EC: mounting of the suspended air handling unit in a flat

In this video the VENTS team will show the mounting of the air handling unit in a flat, to be exact in a flat with no windows. As this bedroom has no windows, the window ventilation is not possible. An air handling unit with heat recovery is a good ventilation solution for bedrooms with no windows. The VENTS VUE2 250 P EC air handling units with heat recovery is intended for ventilation of a flat. It is also applicable for installation in a dressing room or a bedroom with no windows. The ventilation unit is designed for ceiling mounting or mounting into drop ceiling spaces. The VENTS experts will suspend the air handling unit at the balcony. While mounting we have to remember to provide free servicing access to all parts of the ventilation unit for maintenance and repair. The air ducts are laid at the balcony and later we cover the wall with plasterboards. The PLASTIVENT flat air ducts are recommeded for use in spaces with limited installation areas in the drop ceiling. The maximum air capacity of the unit with air filtration is 250 m3/h. The air handling unit consists of two heat exchangers. These generate no condensate, are frostproof, able to recover up to 85% heat energy and maintain the air humidity. EC motors are cost saving and have only 125 W power consumption. To enable an extract bathroom ventilation our mounting team will additionally install the VENS Quiet-STYLE fan with max. air capacity 90 m3/h.